![]() ![]() ![]() Click on the red box that appears next to the text and drag it along the curve to where you want it placed. You can also adjust where the text is along the curve by selecting it with your Pick Tool. Tick Snapping: Specify spacing increments for snapping text to the path Mirror Text: Flip the text from left to right or bottom to top Offset: Move the text closer to the end or start of a path by specifying positive or negative values Text orientation: Specify how the text bends to follow the pathĭistance from Path: Specify the distance between text and path These give you more control over the placement of the text around the curve. Selecting both the circle and the text allows you to use the Fit Text to Path menu tools. The pointer changes to the Fit Text to Path pointer. Drag the text (use the red 'diamond') to the outside of the circle until it snaps to the top of the characters (ascenders). If you double-click on the blue line, you will add an additional node that allows you to curve your text differently. Click and drag the blue line to curve your text. ![]() Use the two mirror buttons in Property Bar, to get the text mirrored and upside down. First, you need to select the text you wish to curve and click on the Envelope tool. Use the Text Tool to select just the text, and change the font, size, kern or any other editing that you would normally do to the text. To fit text to a path 1 Using the Pick tool, select a text object. With the Text tool, start typing anywhere on the outline (edge) of the circle. Here is an example of logos with the top pin straight, and a simple example of why 'arch lower' still arches the top: Any help would be greatly appreciated. It does not keep the top of the text straight. Once you have your text in place, you can use all of the standard tools available for editing text, as well as manipulating the fitted text. Best way to arch the bottom of text while keeping the top straight The obvious answer is Warp>Arch Lower. When you click on the mouse with this cursor showing, the text will conform to the inside of the circle. Clicking the mouse with this cursor showing will place typed text onto the page of the circle.Ĭursor 3 appears when the cursor is moved just to the inside of the circle and is the Paragraph Text Tool. Each shape is pictured and described below.Ĭursor 1 is the standard text cursor and will produce text anywhere on the page.Ĭursor 2 appears when the cursor is right on top of the circle. Depending on how close you place the cursor to the circle, you will see the cursor change shape. Next, select the Text Tool on the toolbar and line up the cursor with the circle. Use the Ellipse Tool (circled in green on the toolbar) and draw any size circle for our example. Well, it’s possible in a few easy steps in CorelDRAW! Follow the directions below to see how you can master this technique. Have you ever had that engraving job that would have looked even better if you could have just curved the text around the photograph, or been able to have the text along a line you drew? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |